Then release them at the same time.ģrd Step: Point the universal remote control in the direction of the device and press the power button once. Hold on to them until the red light turns on. If the device responds accordingly, then it has been set up.ĥth Step: If it does not respond (if there is more than one code for a device), repeat the steps with the next code in the list until you find the correct one.ġst Step: Turn on the device that you want to control.Ģnd Step: Press and hold the device’s button and the power button, both simultaneously. After pressing the last digit of universal remote code, the red light will turn off.Ĥth Step: Now check the controller by pointing it in the direction of the device. If it has its light, it will turn on.ģrd Step: Now, enter the universal remote control code from the list given below. Once you see the red light, the controller is in setup mode.Ģnd Step: Now press the device button that you want to operate with the universal remote control. There are two simple methods to program a universal remote.ġst Step: Press and hold on to the setup button. ![]() Now it’s time to program a universal remote for the desired device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |